Bob,
Think it was a simple matter of not adjusting the front panel MIC gain
up when I went to Line-In setting. That's working, but the hassle continues.
Yes, I've got the latest 1.58, 1.48. At the moment I'm doing USB rather
than data mode. I tried your suggestion for data mode with dataA, and it
works the same also.
I was going to use VOX instead of a physical PTT, but that doesn't work
well. I've adjusted gains but it insists on cycling on & off. Thought
anti-VOX would fix, but it doesn't.
So I tried manual PTT with front panel button to transmit ... getting
feedback somehow when I put the mic gain up to about 4 for even just 1
bar ALC. Have power set to 5 watts.
Alan
--
Alan D. Wilcox, W3DVX
570-321-1516
http://WilcoxEngineering.com
Williamsport, PA 17701
------------------------------------------------------------------------
rkayakr wrote:
Alan
There were some problems with setting "Line in" that have been cleared up
with the last two firmware releases. The audio data modes now seem to work
well, so I would ask the obvious questions:
Do you have the latest firmware?
Is mode set to "data"?
Is data mode set to "data A"?
With my computer audio output at a 50% setting a low K3 "Line IN" level of 3
to 5 is sufficient.
Bob
KD8CGH
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
