Ed,
I just went through this last week. It is a known problem and is on
Wayne's things-to-do list. What ever you do, don't press the SPLT button to
go into split mode when you have the condition you described because if you
do, you will screw up the band sequence when you step through the bands. At
one point I had 3 80m bands and no 60m and 40m when I cycled through the
bands. Until Wayne gets it fixed, be careful to not have different bands in
VFO A and B.
John [K7SVV]
----- Original Message -----
From: "Ed K1EP" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, January 17, 2008 5:16 PM
Subject: [Elecraft] K3: Strange VFO Behavior
I noticed this behavior this evening and I was wondering if anyone else
could duplicate it.
I have VFO A on 6M USB and VFO B on 10M USB. When I turn the VFO B knob,
the VFO frequency changes, but the mode changes to LSB. If I turn VFO A
now, the VFO A frequency changes and the mode goes back to USB. If I do a
band down, I don't get 10M on VFO A, instead I still see 6M, plus get a
PLL error message flash by.
Does anyone else see this?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--
No virus found in this incoming message.
Checked by AVG Free Edition. Version: 7.5.516 / Virus Database:
269.19.6/1229 - Release Date: 1/17/2008 11:12 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
