Your external meter is intended to be used in a 50 ohm system,
right? But in this situation your KAT3 internal tuner has
transformed the output so that you don't have 50 ohms at the KAT3's
output terminals (It has matched the load) and therefore not at the
external meter's input terminals.
So the external meter numbers are not valid in this case. Trust the
KAT3. Also - you will have a slight loss in the external meter in
this situation - I would remove it.
Jerry W4UK
At 01:51 AM 1/29/2008, Tedd Wong wrote:
I am attempting to tune a Zero-Five Vertical with the KAT3. How do
I determine if the KAT3 has found a match? I see the SWR on the K3
close to 1:1and full power out but my external SWR meter is still 5:1. Thanks.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
