Thanks for checking that Don. I'm not in front of my radio so could not verify what bands were actually used now. I wasn't aware of that change and will update the FAQ this evening.
BTW...you already can adjust the TX EQ setting during transmit. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 K3#0009 On Fri Feb 1 6:12 , "Don Nesbitt" sent: >Hello Paul - the TX EQ steps on my K3 are 50 100 200 400 800 1200 2400 and >3200. I've not looked at the FAQ Page but perhaps that was an early version >and has since been changed and the FAQ ought to be changed to reflect >current status. '73 es gud dxing -- Don N4HH K3 #83 > >-----Original Message----- >From: [EMAIL PROTECTED] >[EMAIL PROTECTED]','','','')">[EMAIL PROTECTED] On Behalf Of Paul Christensen >Sent: Friday, February 01, 2008 8:58 AM >To: [email protected] >Subject: [Elecraft] K3 TX EQ > >Wyane & Eric: > >I noted the following from the Elecraft K3 FAQ page concerning the K3's TX >EQ settings: > >> "The bands are centered at 200, 400, 600, 800, 1200, 1600, 2400, and 3200 >> Hz. We can easily change these if something else turns out to make sense. >> Also note that TX EQ will be adjustable while in TX mode..." > >As long as you're open to suggestion, I would strongly recommend using >slightly different centered bands of 50, 100, 200, 400, 800, 1600, 2400, >3200 Hz The lower limit of 200 Hz will not allow the user to optimize low >frequency voice tailoring and adequate notching of the 150-200 Hz spectrum >without sacrificing low-end content. As SSB transmit B/W narrows, >articulation is significantly improved by narrow subtraction of the 150-200 >Hz spectrum while maintaining adequate amplitude of approximately 80-100 Hz >(assuming the K3 will pass this degree of low-end spectrum owing to the >carrier set point placement through the crystal and DSP filters). The user >could then accomplish this effect by adjusting the 100Hz and 200 Hz >settings. > >Also note that unlike the current K3 band centers, when beginning with 50 >Hz, each successive band increases in exactly one-octave increments. Thanks > >for your consideration! > >Paul, W9AC (K3 on order) > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com > > >-- >No virus found in this incoming message. >Checked by AVG Free Edition. >Version: 7.5.516 / Virus Database: 269.19.17/1253 - Release Date: 1/31/2008 >9:09 AM > > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
