After six months of operating, my k2/100 shows high swr/hi curr when connected to the dummy load. Running in battery/qrp mode, everything is fine, so I suspected something in the PA. I checked R26/R27 and they showed about 25k ohms each which seems a bit low (the alignment step calls for 43k ohms). I looked at the schematic and decided to test D16 and D17. D16 shows 0.057 volts both ways and D17 shows about 0.3 volts. Is D16 shot? Thanks,
Kirk, KA2P _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
