Hi Gary, Supply voltage is 13.0V as it has been since I put together the K2. At 1W out the voltage is at 13.0. At 100W out the voltage is 12.8V. The rig hangs up at all power levels.
Serial #3481. It has been working fine for over 4 years. N2TK, Tony -----Original Message----- From: Gary Hvizdak [mailto:[EMAIL PROTECTED] Sent: Friday, February 01, 2008 8:05 PM To: [email protected] Cc: [EMAIL PROTECTED] Subject: RE: [Elecraft] K2 - hang up problem On Fri 1 Feb 2008 at 19:14:13 EST Tony Kazmakites (N2TK) wrote ... Before I tear into the K2 to find out what happened today I figured I would ask on here in case someone has seen this problem before. It receives fine on all bands. When I transmit (does not matter what power level or what band) it hangs up. If I keep it on the transmit mode power out is fine. If I let it go back to the receive mode the receive signals are very, very weak. If I talk into the mike, there is no power out and I have side tone in the headset so I can listen to my transmit audio. To correct this problem I need to change bands or shut off then on the radio. Anyone hear of this problem before? Tnx for any ideas before I pull out the schematics and take off the covers. -- Tony, A couple of questions ... 1) What is your supply voltage? Under no load? Under load? 2) What is your K2 life story, i.e. S/N, how long had it been operating just fine before this problem surfaced? 73, Gary KI4GGX _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
