My PC to KPA100 communication suddenly failed. Checked the cabling and did some initial tracing from J1 to U4. Seems ok incl. RFC:s. I found deviating voltages on U4 pins: 2 -5,5 3 -10,7 4,5,6 -5,5 7,8 -10,7 with remaining U4 pin readings ok. Then tried to find the 16293 kHz signal on my SW receiver but couldnĀ“t hear it. I however find -75 V at the end of the diode chain.....so is the HV xtal oscillator at fault or not? Any suggestion on what to do next is much appreciated! Thanks, 73, Per SM0WRA . K2 no 1623, K1, KX1
-- View this message in context: http://www.nabble.com/RS-232-communication-failure-KPA100-tp15560369p15560369.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com