So if I never get above 35 wpm under and circumstances, I don't need to rush to this update?
----- [Elecraft] Important K3 Firmware Update, MCU rev 1.69 (WAS 1.68) wayne burdick n6kr at elecraft.com Wed Feb 20 14:22:09 EST 2008 A customer just alerted us to a firmware issue in CW mode. When using external keying (handkey, computer, or external computer) or the internal keyer at over 40 WPM, the K3 may switch to the wrong receive VFO frequency, crystal filter, and/or preamp setting on key-up. It appears that this behavior has been present since MCU revision 1.62. While these symptoms should occur rarely, we recommend that everyone update their K3 MCU firmware to revision 1.69. (1.68 had just been released yesterday.) Sorry for the inconvenience. 73, Wayne N6KR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
