Stewart, I also use a Microham device (MK2R+). Click SETUP for the radio port on the PORTS tab. Set the radio to NONE and disable querries. Save the configuration as something like "K3 Firmware". Now it should work fine. It may be a little slower than a straight native COM port, but it has worked fine for me for the past 4 months or so.
Now whenever I need to update, I just click that preset and there's no problems. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 K3#0009 On Thu Feb 21 4:58 , Stewart Rolfe sent: >[EMAIL PROTECTED] wrote: >> Hi Stewart, >> >>> I'm sure it's just in a coma and wonder if anyone here knows how to >>> resuscitate prior to Aptos waking up; maybe I should play some music to >>> it, always thought the K3 would be a Frank Zappa sort of radio..... >>> There must be contingency plans for repairing wiped out firmware such >>> as would happen if a power cut occurred mid way through a re-flash so >>> I'm not panicking (yet). >> >> >> Try doing this: >> ================================================ >> Forcing a Firmware Download >> >> If you accidentally load an old or incompatible >> firmware version and find the K3 unresponsive, do >> the following: >> >> (1) unplug the K3 from the power supply and wait 5 seconds; >> >> (2) plug the power supply back in; >> >> (3) hold the K3?s POWER switch in; after about 10 seconds, you?ll see >> the TX LED flash (you?ll also see MCU LD on the LCD); >> >> (4) load the correct firmware version. >> ================================================ >> From page 42 of K3 Owners Manual C1.pdf >> >> vy 73 de toby >Toby and Ken, > >I tried a 'Force Firmware Download' but got the response from the K3 >Utility of no response from the K3. Then I remembered I use a virtual >com port via my Microham cw keyer and the usb router; this normally >works fine but I tried a direct hardware comm port connection and the >'forcing' worked....! so all is well now and many thanks for the quick >responses to you both. > >Presumably the interruption screwed the virtual com port software >interface while leaving the hardware port unscathed. I've just >reconnected the Microham and reset the port settings and all is back to >normal between the radio and upload utility. > >73, > >Stewart, GW0ETF >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
