Curt...
I put a full complement of re-work eliminators in my K2, even though I had
bought all the options - and installed them. I thought it very helpful to
just work along and not have to worry about desoldering, cutting, pulling,
etc as each option was ready. I have at one time or another pulled out an
option to do something else with the stock K2, and in such cases having the
re-work eliminators in place made it much easier that would otherwise be
the case. The cost is minimal, and the actual workup and installation very
easy. I recommend them.
...robert
At 02/23/2008 07:05, Curt wrote:
I've ordered a K-2 and contemplate adding the KSB2 and the KAT2 someday.
Most likely will not implement any other options, mostly operate QRP CW.
I'd appreciate comments about whether the re-work eliminator kits would be
appropriate, or just an unnecessary expense.
72, Curt KB5JO
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
Robert G. Strickland PhD ABPH - KE2WY
[EMAIL PROTECTED]
Syracuse, New York USA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
