Norm,
Do you have CW sidetone? Switch to CW and press SPOT to check. If
there is no sidetone, you likely have the sidetone source incorrect.
Enter the menu for ST L and edit the parameter - then tap DISPLAY until
you hear sidetone, then stop and exit from the menu.
U6 pin 25 used to be the source for sidetone but that was changed to
U8-4 when the KIO2 (and KPA100) needed to use U6 pin 25 for TXD. The
firmware supports both sources so the older K2s without the sidetone
source mod will work with the new firmware - however this capability to
support older K2s does have its downside - sometimes the sidetone source
is inadvertently changed and neither the sidetone nor the TXD signals
are correct.
If that does not fix it, ask again please.
73,
Don W3FPR
Norm wrote:
Hi All,
My K2, KIO2 quit. I traced the problem to pin 25 on U6. It has 2mV
on it,
(should be 5V). Any one have ant idea where to look from there?
The rest of the radio seems to be working properly.
Thanks, Norm
____________________________________________________________
FREE 3D MARINE AQUARIUM SCREENSAVER - Watch dolphins, sharks & orcas
on your desktop!
Check it out at http://www.inbox.com/marineaquarium
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
