Hello Builders,
I am working through the steps for the K2 control board. I am at the
point where I am getting ready to install R18 and R19 on the bottom of
the Control Board. I am not 100% clear on "Install short wire jumpers at
R18 and R19..... on the top side of the board."
I realize that these pins are shared with J1 and J2.
1. Am I supposed to have short wires in the each of the pins but not
connected to anything else?
2. Am I supposed to short/jump J1/1 to J2/1.... J1/2 to J2/2
3. Am I supposed to short/jump J1/1 to J1/2.... J2/1 to J2/2
4. Something else completely different?
Does anyone have any pictures and/or can you explain this to me?
Thanks, JH
--
John Hoaglun
NG0R - EN25
http://www.hoaglun.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
