Thanks Jim! This split issue has been listed and Wayne is working it. It's not in the release that is in testing now but should not be far behind.
You're right about the CAT commands. The K3 needs to send a different mode report for FSK and PSK direct modes other than data so that devices like the MicroKeyers and Navigators as well as digital mode programs know the difference. You're dead on though....after the sub receiver is done. 73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of James Denneny Sent: Saturday, March 01, 2008 6:02 AM To: elecraft@mailman.qth.net Subject: [Elecraft] K3 Fine/Coarse VFO settings Eric / Wayne - This may be pilot error on my part as I have only had the radio a few days but I noted a nuisance issue during the ARRL SSB DX Contest. I was operating split vfo on 40M. Both VFO's were set to fine tune. I decided to switch vfo B to coarse so I could qsy rapidly to an announced qrg frequency above 7125. I discovered if I set vfo B to coarse tune that vfo A also switches to coarse tune. It would be slick if the firmware enabled independent switching of vfo A or Vfo B to fine/coarse. That would enable fine tuning for stations on vfo A while coarse tuning vfo B in split operation. I realize it is possible to enter vfo B freq from keypad but that would be awkward and a hassle in an ssb contest situation on 40M. I also hope that as soon as the second receiver design issues settle that Wayne will be able to produce the complete programmers reference manual. My Microham Microkeyer has the hiccups with the K3 in some modes. Thanks for your consideration 73 Jim K7EG _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
