Oh for crying out loud, Tom... you give them a correction and then
SCREW IT UP YOURSELF!
CORRECTION TO BE MADE TO YOUR K3 OWNER'S manual NOT the K2 Manual.
Sorry guys.
Never claimed to be a good typist.
Thanks,
Tom
At 18:59 03/04/2008, [EMAIL PROTECTED] wrote:
Make a correction to my "K2" Owner's Manual????????
Chuck Bland
NA6BR
= = = Original message = = =
Folks:
Just to no one will go off in the wrong direction when attempting to connect
to the K3's RS-232 port...
On page 18 of the K3 Owner's Manual, The table associated with RS-232 shows:
Pin # Description
1,6,8,9 Not used
2 RXD IN (data to PC from K3)
3 TXD OUT (data to K3 from PC)
4 DTR (see PTT and Keying, below)
5 Ground (RF isolated)
6 RTS (see PTT and Keying, below)
Obviously, pin 6 can't be 'Not Used' AND RTS at the same time...!
RTS should be assigned to pin 7, and pin 6 really is NOT USED.
Please make a pencil correction to your K2 Owner Manual.
73,
Tom Hammond N0SS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
___________________________________________________________
Sent by ePrompter, the premier email notification software.
Free download at http://www.ePrompter.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
