Good morning, Lee. Per the C1-3 Errata (Feb 1), CONFIG:TUN PWR was added to
control the power level at which the TUNE button works, so that function is
controllable.
However, the same errata states that, "Note: TUN PWR does not pertain to ATU
TUNE, which always uses 5 or 10 W and is internally controlled."
It would seem to me that if you can tune at 2 or 5 watts, there's no point in
running it at any higher level. Itune my remoted LDG autotuner at 2 watts, and
could most likely crank it down some more.
It is getting harder to keep track of changes with all the errata scattered on
the table. I may have to use the electronic versions & create a "master errata"
sheet instead of looking at individual pages.
Lee Buller wrote:
How does the K3 Tuner work? Does it tune at a lower wattage?
73,
Mike
KW1ND
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
