Paolo,
The only 'wrong' thing is that you did not heed the information in the
Firmware section of the Errata sheet - which points out those things not
yet available. Method 3 is not yet implemented. Use one of the other
methods until the supporting firmware has been released.
73,
Don W3FPR
IK4YNG wrote:
Hi all,
when i try to calibrate my TXCO using method 3, i'm unable to proceed.
I locate the CONFIG:REF CAL, but when i tap "1" (i mean, the key labeled 1
in red) the name does not change to REF xxC; all i get is a A/B VFO flip.
Where am i wrong?
73,
IK4YNG Paolo, K3#517
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
