I had a 1D 10 T error... Problem found to last post; Wireing error within the MH2. I did the fixed audio mod to the mic connector at pin 8 then wired the MH2 wrong... Go figure.
Damon - KC5CQW wrote: > > Now I have a "new" problem. It seems that my front panel is very > positional when I mate it back onto the K2 main body. Audio is lost and > really strange things happen when I plug in the MH2 mic... > What gives... > Damon KC5CQW > > > > Damon - KC5CQW wrote: >> >> Below is some of the text that I sent to Gary. >> Basically, if I use the KAT2 to tune my 40m attic dipole the PA finals >> will short out. >> I haven't tryied to tune any other antennas because I don't want to pay >> for any more PA kits ($18.50 'ish each time I tune up). >> Also, CW is un-usable above 80m and no CW output on 10m (SSB and "tune" >> yield 8.5W) >> >> See text below... >> >> 73, Damon KC5CQW >> >> Copied text from support email: >> >> On 40m-10m when I release the CW key or mic PTT in CW mode, the moment it >> is released I get a power spike resulting in a HiCur warning. >> On 12m and 10m I have no output during key down; Only the power spike. >> (CW only, SSB is fine) >> If the tune button is activated, The radio will give about 11w Max on 12m >> and 8.5w on 10m. >> All other bands yield 12-15W max. >> >> >> At the time of the last PA meltdown, I was able to tune my 40m dipole on >> 80, 40 and 10m; It failed at 30m. >> There seems to be no rhyme or reason as to when a failure will occur. It >> has happened at different frequencies. >> I am reluctant to use the KAT2 except in bypass from this point on. >> I don't seem to have any problems with my MFJ-969 Versa Tuner II. >> >> During some KAT2 troubleshooting, I found that the voltage on pin 1 of U4 >> was about 2.5VDC (3-4V spec at 5W) with a leg of R6 lifted. >> Perhaps I'm not having a mechanical short on the LC board. Maybe the >> SWR/Power bridge is sending the wrong data. >> If I tune up on 10m into my dummy load, the K2 reports a 2.1:1 SWR. My >> MFJ-969 read 1.05:1 >> >> The best I can tell, everything seems to be fine on the SSB modes. I >> can't help but think however, if a problem in CW if occurring that I may >> have some distortion on SSB. >> >> >> > > ----- Damon Wascom KC5CQW Elecraft K2 #:6351 Build: 12/28/07-01/01/08 -- View this message in context: http://www.nabble.com/K2-Transmitter-and-KAT2-failures-tp15883353p15912880.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
