Roy Morris-6 wrote:
>
> The new NORM values ALT1 and ALT2 do not show up as I or II on the display
> when saved. Once the bandwidth has been saved into ALT1and ALT2, holding
> down the NORM knob and turning it to the desired bandwidth does not change
> the I or II icon in the display. I suspect this is because holding the
> I/II knob down has nothing to do with the bandwidth memories entered and
> saved via the NORM knob. In other words, ALT1 and ALT2 are not the same
> thing as I/II. I hope I understand this correctly.
>
I think of it as follows:
1. NORM settings are fixed by the factory and not alterable by the user.
2. ALT1 and ALT2 are set by the user and are alterable (if new settings are
saved).
3. I/II are "scratchpad" memories that recall the last setting they were
set to.
73, Bill W4ZV
--
View this message in context:
http://www.nabble.com/K3-MCU-1.75-Firmware-Revision-tp15919836p15919998.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
