Scott,
You apparently have no BFO, and the product detector will not produce
output signals without a BFO, so the lack of audio is to be expected
with no BFO.
To make email communications simpler, look at the RF board schematic
sheet 2 and locate the components in the lower right corner (labeled
BFO). Check and re-check all those components. If you have a separate
set of eyes available, ask that person to examine it too - often someone
else can spot a problem that we have overlooked many times.
Make the DC voltage checks at U11 just to be sure it has voltage to it
in the right places. You can also check L33 for continuity to be
certain you have properly soldered those tiny leads to the resistor
(actually an insulator with leads).
Be certain D36 and D37 are the right types, and are oriented correctly
(check the parts placement diagram at the back of the manual to verify
orientation).
Once you are convinced that all above is correct, build up the RF probe
from the parts provided with your K2 and measure the RF voltage at U11
pin 6 (should be 70 mV rms or greater).
73,
Don W3FPR
[EMAIL PROTECTED] wrote:
Hi
I'm building a K2 and had a problem with not being able to
adjust L30, which I got corrected with Don's help.
So all test and alignment procedures have gone as they were
supposed to up until the BFO test. I get no frequency reading
on TP2, and have no audio from the receiver. I've re-soldered
all the joints and checked all components, and there were as
they sould be.
Anyone have any ideas?
Thanks
Scott N5SM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
