Stewart, Try installing the new firmware again. I just tried to recreate your report and the radio performs as expected...no problem with RX after a transmit with ALT1 set to 0.15 on the LO side.
73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Stewart Baker Sent: Sunday, March 09, 2008 11:32 AM To: Elecraft Reflector Subject: [Elecraft] K3 - RX Problem after latest firmware update I am not sure if there is an obscure problem after the latest MCU and DSP update. Maybe others could check and see if it happens to them ? Any band on SSB if I have the DSP set to ALT1 with the Low Cut set at 0.15 Hz , then after going onto transmit the receiver appears to be dead. If I set the DSP to NORM by pressing the knob the receiver suddenly bursts into life... This happens whether there is any transmit audio or RF out. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com No virus found in this incoming message. Checked by AVG. Version: 7.5.518 / Virus Database: 269.21.7/1322 - Release Date: 3/9/2008 12:17 PM No virus found in this outgoing message. Checked by AVG. Version: 7.5.518 / Virus Database: 269.21.7/1322 - Release Date: 3/9/2008 12:17 PM _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
