To all who are missing a easy way to configure the RX/TX equalizer.
Based on the available tools i would use the Macros to set the RX/TX
equalizer for different needs.
An short example (pls don't type in the comments...):
AI0; no response
K31; is needed to use the SWT command
MN008; or 009 to select RX / TX equalizer
SWT53; tab CLR => set all values to 0dB
SWT11; tab A/B => select first frequency
11 A/B (1) => select 50 Hz
12 REV (2) => select 100 Hz
13 A>B (3) => select 200 Hz
24 PRE (4) => select 400 Hz
27 AGC (5) => select 800 Hz
29 XFIL (6) => select 1200 Hz
33 NB (7) => select 2400 Hz
34 NR (8) => select 3200 Hz
UP; to set +1 dB
or up to 16 times each !!
DN; to set -1 dB
MN255; exit the menu
K30; back to default (optional)
This one will set TX-EQ to -3/-2/0/0/0/+2/+3/+3 (this is only an example...
pls don't ask why....)
AI0;K31;MN009;SWT53;SWT11;DN;DN;DN;SWT12;DN;DN;SWT29;UP;UP;SWT33;UP;UP;UP;SW
T34;UP;UP;UP;MN255;K30;
73 Thomas, DM7TN
K3/100 #78
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
