I used one of the felt washers to cushion an adjustable spanner (is
that a crescent wrench?), then used it under the knob as instructed.
--
Everything secret degenerates, even the administration of justice;
nothing
is safe that does not show how it can bear discussion and publicity.
-Lord Acton, historian (1834-1902)
On 11 Mar 2008, at 14:54, Vic K2VCO wrote:
Lee Buller wrote:
I just used a crescent wrench to do the job and was very careful with
it. I guess that is my version of a Spanner Wrench.
You are lucky if you escaped without scratching your panel! I use
nutdrivers for this kind of thing, and also install a smooth flat
washer behind the nut -- or I use a knurled nut rather than a hex
nut and tighten it by hand.
If one doesn't have a nutdriver, a normal mechanic's socket (held in
the hand, not attached to a ratchet!) works.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
