Hi This is usually caused by the 8 volt regulator output on the low side of its tolerance. Check the 8 volt supply if it is low say around 7.5 volts ask support to send you a replacement. In the mean time just go ahead with the build the agc and S meter are finalized later in the alignment. Don Brown KD5NDB
> From: [EMAIL PROTECTED]> To: [email protected]> Date: Thu, 13 Mar 2008 > 08:36:55 -0400> CC: > Subject: [Elecraft] K2 AGC/S Meter> > Building K2 S/N > 6430 and at page 48, AGC and S meter alignment. I can only> get a maximum of > 3.60V from the pin 5 of U2 with R1 set at its ccw limit.> Additionally, for S > meter alignment, both CAL S LO and S HI I am not seeing> the LEDs illuminate > at all with either dot or bar settings. All other tests> up to this point > have worked as described. Any thoughts on where to look?> > > > Thanks,> > > > > Tim> > KK9T_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
