Paul. Please check your errata sheet. This calibration method is not yet implemented in the firmware. Best method to use right now is to use WWV until the FW is ready for method 3.
73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Paul Christensen Sent: Friday, March 14, 2008 7:16 PM To: [email protected] Subject: [Elecraft] K3 RF REF CAL Procedure Trying to get my K3 to go into Reference Oscillator Calibrate routine using Option #3 (temp compensation). I have "Tech MD" enabled [ON], but I cannot toggle out of "REF CAL" to get to "REF xxC." It just stays on "REF CAL" regardless of tapping the "1" button on the numeric keypad. Latest K3 firmware is installed. Ideas? Paul, W9AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
