Be sure you put the boards in the K3 sunny side up, Fred :-) 73, Bob N6WG
----- Original Message ----- From: "Fred Jensen" <[EMAIL PROTECTED]> To: "Elecraft Reflector" <[email protected]> Sent: Saturday, March 15, 2008 2:52 PM Subject: Re: [Elecraft] KAF2-Assembly questions > Andrew Moore wrote: > > Reference: > > > > http://www.elecraft.com/kaf2/kaf2_side.jpg > > > > Thanks Andrew. As has happened with every kit I've built, I got the > sides of the board mixed up, the picture made that clear. It seems that > after I get components on each side and they look sort of similarly > populated, and have been building for a couple of hours, this happens. > I was able to get the two trimpots out and installed on the proper side. > I am now going to take a break until tomorrow evening :-) > Fortunately, this isn't likely to be a problem when my K3 gets here > although some other technical difficulty in my mind will probably arise. > > 73, > > Fred K6DGW > - Northern California Contest Club > - CU in the 2008 Cal QSO Party 4-5 Oct 08 > - www.cqp.org > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
