I haven't built my XV144 yet, but I think this is covered in the Owner
Manual pg 36 (Using Transverters)
--
When you want to test the depths of a stream, don't use both feet.
-Chinese Proverb
On 19 Mar 2008, at 02:23, Phil Theis wrote:
Given the following setup: K3 using transverters, with 50MHz
transverter set for xv1.
When I enter a 50MHz frequency via the com port the built in 50MHz
receiver is selected. I then have to band up once to get to the
xv1, then I can successfully band up to 144 etc. If I enter a 144
frequency, it immediately goes to xv2.
What would it take to get a serial command to go to a frequency in
50MHz range to go directly to the xv1 selection?
thanks
Phil K3(352)TUF
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
