It says right there on the site that all Rev B boards have the update. Read the rev of your board and that is your version control. What more do you really want?
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dave G4AON Sent: Friday, March 28, 2008 2:15 PM To: [email protected] Subject: [Elecraft] K3 board - lack of modification version control Mike Would you care to elaborate? In the past when I worked for one of the large European manufacturers they had very strict version control, when a change was implemented the updated version number was written in black marker on the board, with the board number followed by "/01", etc. In the case of military kit, or kit that may be used by the military, there had to be a "mod state" plate on the outside of the equipment too. I received a replacement PA and driver board from Elecraft and there was no way to distinguish the updated driver board from the earlier one! The PA was easy as it had two resistors in parallel in place of the single ones at (I guess) R4 & R5... But no markings that were obvious to me. 73 Dave, G4AON ---------------------- "They did." _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
