>From the description of your problem it could be your power supply. Check the power supply voltage with a analog or digital voltmeter, under load it should not drop below 12V. The K2/ KPA100 requires a good high current power supply. I use an Alinco DM-330MV set to 13.8V. This power supply is rated for an output current of up to 32 Amperes.
GL 73, Bob Johansen WB2SRF K2 S/N 5622 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
