Tom,
Here is what I did, click on K2 diffuser
http://www.heavymetalradios.com/
I think Elecraft recommends soldering it together without a mechanical
connection. Hope this helps.
Best,
DW Holtman
WB7SSN
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Sunday, March 30, 2008 4:09 PM
Subject: [Elecraft] K2 Backlight LED leads too short
My K2 backlight assembly is to be mounted 1/8" above the board but the
leads to the LED's are 1/8". Is there a solution or special technique to
install this that is not spelled out in the manual?
73,
Tom
KB3PNU
Wimsatt Website:
http://wimsatt.truepath.com/
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
