Don,
What answer of Lyle's are you referring to? I think I asked the original
question, but didn't get that answer, as far as I know. Thanks.
73, andy, ae6y
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Cc: "'Andy Faber'" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Monday, April 07, 2008 10:17 AM
Subject: Re: [Elecraft] Audio problem in WPX SSB
Joe,
Check Lyle's answer yesterday to similar questions. It is a known problem
and the fix is being field tested right now. You can expect the firmware
release to fix it in about a week according to Lyle.
73,
Don W3FPR
Joe Subich, W4TV wrote:
With the K3, the messages play fine, but after one finishes, if I use
the mic, the radio starts out at lower power and takes 2-4 seconds to
build back up to high power. This is the same whether using the front or
rear input and whether using high or low gain.
I've noticed the very same thing with the microHAM microKEYER II and its
software DVK. I have not had time to further diagnose the issue and
check it with other interfaces but it is quite pronounced.
There is no difference if using FP.L or FP.H when the MK II output is
adjusted for four to five bars of ALC. Bias is OFF and the microphone
output of microKEYER II is capacitive coupled (top and bottom) so there
is no "DC effect."
I will not have time to look at this issue further until later in the
week.
73,
... Joe, W4TV
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
