Dick,
Check out this application note at the Elecraft website -
http://www.elecraft.com/Apps/Power_Control_Mod.html
Each K2 is a bit different in the overall transmit gain, so for most
stable operation, the value of R98 must be determined experimentally.
Be aware that increasing R98 too much will result in a power output drop
on 10 meters (the band with the lowest transmit gain), so some
compromise must be made - you select how much power reduction on 10
meters is tolerable for you.
73,
Don W3FPR
Dick Grolleman wrote:
Hi All
I'm using my K2/100 to drive my Amp with 50 watts. But the output power is not stabel. When set to 50 watt the power goes from 50 to 100 and back, wich causes to much drive for my Amp. Other then that the K2 works fine with 100watts, barefood.
Any one knows this problem? And more important, how do is solve it.
My K2 is serial nr 4072. It's build in sprng 2004. Rev B KPA100
Have the K3 on order, have to wait a few more months
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com