Oops... I just noticed that you had already mentioned that.
Sorry...
73,
Ken K3IU
~~~~~~~~~~~~~~~~~~
Ken K3IU wrote:
Scott:
You might also check to see that the shorting block on P7 on the
Control Board is in the correct position. If you have it in the EXT
position, then, if I remember correctly, you will get the Low Battery
warning.
73, Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~
Scott McDowell wrote:
Hello
For some reason the low battery messages keeps poping up on my K2
in the receive mode.
I have the p7 jumper on the internal side, and have tried it on the
external pins, but I still keep getting the low battery message.
On my first K2 I had the battery deal turned off, but don't see
anything
in the manual on how to turn it off on this one.
It's drawing 240 ma on receive and the internal volt meter doesn't work
but the power supply voltmeter shows 13 volts.
Any ideas?
Scott
N5SM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
