What is the level output of the I F output on the K3? I'm trying to use the
Kenwood SM-220 panadaptor with mine but can't get enough output from the I F of
the K3. I've got on loan an I F amp @ 8.215 mhz set at 15 db gain from Jack of
Clifton Laboratories to try and cure the problem but even with the amp I need a
minimum of 200 microvolts signal input to the antenna jack of the K3 before I
can even detect it on the SM-220 panadaptor I F input even with the 15 db
amplifier. Looking at the schematic of the K3, there should be approximately
the same level coming out of the 8.215 khz I F as what the received signal is.
The manual for the K3 does NOT give any information on this. Any help would be
greatly appreciated.
Thanks from Fern VE7GZ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
