Use RWM on 9996kHz and you will be spot on. I am.
Ian
Ian J Maude, G0VGS
Sysop GB7MBC DX Cluster
K2 #4044 | K3 #455
Sent from my iPod
On 17 Apr 2008, at 08:19, "David Ferrington, M0XDF" <[EMAIL PROTECTED]
> wrote:
Hmmm - I've done the cal quite a few times too - I still get reports
I'm off freq. - the last cal was done by a knowledgeable friend,
using a 5MHz ref source (Racal crystal with oven), closely coupled
to ANT1 input and we got the beat to about 2 seconds (a peak every 2
secs or so) - I still get reports I'm off freq. - I thought this was
me.
will watch this thread with interest.
Any UK K3 owners who 'know' they are well on like to have a sched?
73 de M0XDF, K3 #174
--
Never let your sense of morals get in the way of doing what's right.
-Isaac Asimov, scientist and writer (1920-1992)
On 17 Apr 2008, at 03:52, J. Heide wrote:
I have the K3 put together, went well, but I am having a problem. I
did the reference oscillator calibration using an Agilent frequency
counter with a GPS reference (I use this setup to set my 100Mhz
reference on 6GHz digital microwave equipment). I was testing
tonight with my friend and he was having trouble hearing me,
stating I was off frequency on TX. Our dials matched for me to hear
him fine, and he never had issues when I had the K2 running, our
dials matched. I checked my TX on my IFR1900 and found I was low in
freq by 900 Hz. XIT is off. Filters are FM in FL1, AM in FL2, 2.7
in FL3, and 500Hz in FL4. Data was entered from the crystal filters
properly (I think, looks fine). Where should I look to find the
trouble? I'm stuck on AM right now since it is more forgiving
frequency wise.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
