Ok, as it is now you can open up CW rx all the way to 2.8 kHz if you like with the 2.7 kHz filter installed - and *enabled* for CW mode.
Do you have the 2.7 kHz filter enabled for CW mode? If not, then I can understand the need for this split setup to "open up the DSP filters" for CW rx. Since filters are enabled on a per-mode basis, things can get a bit confusing. Bob NW8L On Mon, Apr 21, 2008 at 6:44 AM, Paul Christensen <[EMAIL PROTECTED]> wrote: > > > In the CONFIG menu, there is a SPLT SV entry which you can turn ON to save > the split. I just tried it on #202 with latest firmware and it works > here.73, Ken K3IU > > > > Ken, > > Good job. With that suggestion, the entire procedure I mentioned > (including split recall) is now automated by saving into memory. (almost > like a macro?) Even better, by activating SPLT SV as you mentioned, one can > band hop and go right back to the saved split settings without having to > recall the memory. For example, I had called the CW Rx split procedure as I > described for 40M -- then tuned around on 20M SSB for a while and came back > to 40M where all settings were brought back with the just the band change > button. Even tried powering down the rig, and all settings came back at > power-up. > > Probably the only distraction with the procedure is that the lower, smaller > frequency display becomes the "real" operating frequency for CW off-set > purposes. Oh, and CW spot will not work this way either. So, opening up > the DSP filters in a future f/w release for CW Rx mode is still the > preferred way of accomplishing this. Still, the flexibility to accomplish > this in the K3 and still retain all the QSK attributes is damn impressive. > > Paul, W9AC > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
