Hi folks. I'm finishing a new K2 for a friend. When I tried to perform the 40m Tx alignment, I instantly get "HI Cur" and the power drops to zero. This happens if the output power is set to anything above 0.3 watts. This only happens on 40 meters. I was able to peak the output on all the other bands normally. The Cal Cur is set to 2.5. I've got the little RF probe built. could someone point me in the right direction as to where to look for the problem? Thank you verrrrrry much! 73, AD5VM Larry Hagood KLA-Tencor Customer Service Engineer Intel Service Business Unit Mobile: 505-563-0338 KLA-TENCOR CONFIDENTIAL This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error, do not use or review the message or any information transmitted with it, and notify the sender. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
