DW,
Do you also have the KAT2 installed in your K2?
If you do, did your see the note with the K60XV that the KAT2 R6 value
must be increased to 470 ohms?
Also:
The power knob does control the power output from the low power output
jack on the K2. With the power knob set at full rotation, what is the
power output displayed by the K2?
73,
Don W3FPR
DW Holtman wrote:
Hello,
I finally finished my XV50, got it debugged and working. Now there is one more
problem/question.
I setting up the configuration, I set the low power out of the K60XV to 1.0 MW.
When I have everything connected, and operating, the display shows that the K2
is only putting our about 0.3 MW instead of 1.0 MW. Is this adjustable? It will
only allow about 8 or 9 watts out of the XV50 instead of 20 Watts, with
everything properly aligned.
Thank you for your help.
Best,
DW Holtman
WB7SSN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
