Hi Tom,
Yes, the K2 has a Squelch feature. It's accessed through the
secondary menu (tap MENU, then tap DISPLAY). Squelch (SLCH) is the
first item on the secondary menu. See page 100 in the K2 manual.
73,
Joe KB8AP
On Apr 30, 2008, at 6:54 PM, KJ3D wrote:
Hello Group,
I recently installed HSE software and ran into an interesting
problem. The
folks at Callsign Software couldn't provide a solution, so here I am.
After the installation, when the K2 was powered up, it would do so
with no
audio - but otherwise apparently working fine. A touch on the key
or PTT
switch brought it back to life, but only for 10 seconds).
Somehow, the HSE program turned squelch full on on my K2 (ser 4991
with SSB
and DSP).
I cannot find a reference to squelch anywhere in the Elecraft
literature,
including how to turn it off.
I did get it off, but it required installing HRD and installing all
the
sliders. One is for squelch and it was full on. Turning it off and
exiting
the program solved the problem.
My question is...
What's the story on squelch? Is there one? How does one access it -
specifically how do you turn it off if it gets turned on by a third
party?
TIA,
73,
Tom, KJ3D
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
