OK, I was waiting to see if the firmware sorted this but it has not. If
I hold tune or use a key, I get full output power on my external meter.
On SSB I get about 40-50W showing on peaks for a setting of 120W. This
is the same whether into my trusty old Sommercamp YP-150Z or via the
Bird into a Termaline. It is also exactly the same into a tuned
dipole. This is also with the TXG VCE set to +3dB!
If I connect the 101Z or another radio into these meters, no problemo.
So can anyone tell me what I am doing wrong? I use a Goldline in the
front connector and currently it is on front panel high with a mic gain
of 10 and compression of 15. That kicks up the ALC just fine.
The K3 is #455 with the stock 2.7kHz filter with FRQ set to -0.91 as per
the label on the filter and no gain.
Ideas please??
73 Ian
--
Ian J Maude, G0VGS
SysOp GB7MBC DX Cluster
Member RSGB, GQRP
K2 #4044 |K3 #455
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
