The K3 Utility Help describes this on the "Firmware" tab: Always load DSP data tables
(Advanced Mode only, intended for firmware developers) DSP1 and DSP2 firmware consists of program instructions and some large data tables. Each DSP firmware revision will change the program instructions, but the DSP data tables are expected to change less frequently. DSP data tables are normally sent to the K3 only when a new DSP data table version becomes available. This reduces the DSP firmware load time. The Always load data tables check box causes the DSP data table to be loaded whenever the DSP is loaded, without regard to the currently installed DSP data table version. Users that aren't DSP firmware developers probably never need to select this checkbox, but if you do, it will just take more time to load the DSP when you select the "Load" checkbox on the DSP1 or DSP2 row. Nothing bad will happen if you check the check box. Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Joel R. Hallas Sent: Sunday, May 04, 2008 4:21 AM To: [email protected] Subject: [Elecraft] K3: K3 Utility v. 1.1.4.1 Question Folks, I just successfully uploaded the new firmware, and especially appreciate the "absolute S-meter" option--makes perfect sense to me! I just noticed something on the utility main page that puzzled me. Not sure if this was on earlier versions, but there is a check box on the utility main page that says "Always load DSP data tables." I have had it unchecked, must be the default, and it was this time as well. There is nothing about it in the "Help" index (that I can find). Does anyone know the correct setting? Under what conditions would I want to, or not want to, load DSP tables? Thanks much! Regards, Joel Joel R. Hallas, W1ZR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
