Mike (N8XPQ) wrote:
The latest update is great, however I am curious as to when some of
the more
basic functions such as squelch, keypad beep, and ESSB TX will be
enabled.
We're working on all of these, Mike, along with the DVR and additional
subreceiver-related firmware.
I have also noticed that after the update, I can only listen out 4 KHz
wide
versus the prior 6 KHz with the AM filter installed.
I assume you're referring to SSB mode. Even though the WIDTH control
went to 6 kHz in SSB modes before, the DSP was actually restricting the
RX bandwidth to about 4 kHz. We'll revisit the possibility of extending
the upper passband in the future.
In AM modes, the WIDTH control now shows the *I.F.* DSP bandwidth (up
to 10 kHz), reflecting an AM RX passband that extends up to about 5
kHz.
Also why not allow RX/TX passband down to 50 or so Hz?
We actually do process signals down to this level, but further
improvement is possible. It's on "the list."
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
