Hi Eric,
This should not have happened. You may need to re-set the filter's
center frequency using the FL5 FRQ menu entry. Typically the 200-Hz
filter has an offset of around -0.90 kHz.
Also make sure that FL5 BW is set to 0.20, and that you have REFCAL
properly calibrated against a reference signal.
73,
Wayne
N6KR
On May 4, 2008, at 10:00 AM, Eric wrote:
Seems I lost my 200 Hz filter after the update. In config the filter
is ON, everything looks OK, but al sigs are lost when FL5 kicks in
when turning WIDTH.
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
