At 19:06 4-5-2008, you wrote:
Hi Eric,
This should not have happened. You may need to re-set the filter's
center frequency using the FL5 FRQ menu entry. Typically the 200-Hz
filter has an offset of around -0.90 kHz.
Also make sure that FL5 BW is set to 0.20, and that you have REFCAL
properly calibrated against a reference signal.
Hi Wayne,
After some filter swapping, it looks like the 200 Hz filter is dead.
It wasn't during the ARRL CW test, last time I used it, so I guess
it's a coincidence and has no connection with the software changes.
vy 73 Eric PA3CEV
PS: no visual problems on the 200 Hz board, all leads are clipped
short etc. Anything I could do myself?
--
No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 269.23.8/1413 - Release Date: 3-5-2008 11:22
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
