Can someone confirm the default file location for the K3 update utility when
updating through the Internet? Tnx!
----- Original Message -----
From: "Lyle Johnson" <[EMAIL PROTECTED]>
To: "G4ILO" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Sunday, May 04, 2008 2:47 PM
Subject: Re: [Elecraft] K3 FIRMWARE UPDATE: MCU 1.87, DSP 1.69 (Finally!)
...listening to the K3 on 29.600 FM via my
FT-817 the audio sounds a bit distorted or "scratchy" on voice peaks
which
suggests that the deviation is too high. I'd like to be able to adjust
this
to see if it is or not.
If you see a dull red glow to the west, it is my face turning beet red.
Reasons/excuses aside, the released code has deviation at about 6 kHz
instead of 3 kHz.
This is now fixed in my development code.
Meanwhile, to set the deviation using K3 Utility:
Click on the Command Tester tab, in the edit line, type
!dd40;
and deviation should be right. This only needs to be sent once per
session. If you leave the K3 on, the deviation setting should not be
changed when you change modes/bands/etc.
Sorry for missing this one, Julian.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
