Dave, the spurious ERR PL1 message is corrected in the latest f/w
release. The error checking code was looking at the PLL too quickly
after a band change. On a small number of rigs this showed up as a
momentary error after a band change. We have now increased the delay
after a band change before checking fhr PLL.
73, Eric WA6HHQ
----
You Wrote:
Elecraft] Initial strangeness
Dick Roth KA1OZ
Sun, 04 May 2008 20:38:58 -0700
To wit...doing the first calibrations. The synthesizer cal appeared to
complete correctly, but when I hopped from band to band, there is a
momentary "ERR PL1" message at VFO B. I don't know if this is normal or not.
--
73,
Dick ka1oz
--
_..._
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
