Hi guys, today I tried to use my paddle trasmitting in FSK mode as mentioned on the manual at page 32.
The TX and RX decode work very well but I found trouble using IM (immediatly exit) or BT (extented timeout). Pratically speaking the above two command don't work ... after write some words the K3 remain in a data idle state for about 4 seconds and after switch to RX mode. The manual said: "To cut short the idle transmit period and exit to receive mode, send ..-- (IMmediately exit). This character is not transmitted as data." But in the reality the IM is trasmitted and the K3 continue the idle for 4 seconds. Some of you have tested this feature ? Maybe I'm doing some wrong ? Any help is appreciated. 73's - Sten _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com