Ian et al,
I did the same thing but found out later that my SSB audio sounded a little
"gravelly" as if I was overdriving early stages of the mic audio amplifier.
This was true even with no bars of ALC showing and with both my MH2 mic and
another backup microphone.
After a lot of tests and trials I finally discovered the problem disappeared
when I set CONFIG.TXG VCE back to 0 db which seemed to make little
difference in my ssb power output anyway. So 0 db is where I shall leave
that setting.
Don K7FJ
Hi all,
I installed the latest firmware this morning but have only just got
around to testing. To be sure, I reset the radio and started the at the
beginning, calibration and all. Having done all of that I set
the CONFIG:TXG VCE menu item to 3.0 dB. The rig now almost gets to the
set power on voice peaks. I would like a little more but it is close
enough and *way* better than the 50% I was getting previously. A
really big thankyou to Wayne, Lyle and everybody else for such a fast
turnaround on a Sunday!!
Many thanks
Ian
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
