Hello,
I did the 1.87 upgrade and today did the 1.88. I did not work any ssb
after doing 1.87 but today saw some posts concerning ssb output to drive
amps, etc. Sooo, I decided to check it out and found that I have heavy
hum on the keying of my MH2. I am set for FP.L with bias....I initially
had the microHam MKset up with MH2 going into the back of the MK (has
several snap on chokes from my O II days) and when keying the mike I
without saying anything, I get heavy hum and 8 bars of ALC; CMP flickers
with about 4 to 5 bars...MIC is set at 20 and CMP at 20 (worked ok in
the past). With CMP at 0, I still get 7 bars of ALC just by keying the
MH2. I can hear the hum when the MIC is anything above 3. I took the MK
out of the circuit...disconnected from computer and exited the
router....MH2 is plugged directly into front panel and all previous
problems still exist...Suggestions?
Is there a way to re-load 1.87 or even 1.86?
73
Tom
CX7TT
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com