Here's what I'm unclear on. If I'm on the 20 meter band and I enter freq 9.8 MHz what happens to my band order as I cycle through them. Have I "replaced" the 20 meter ban with 9.8 MHz.
Another way to ask the same question, if I want to go to 9.8 MHz, should I make sure I'm on the 30 meter band BEFORE entering the frequency? I seem to recall my K2 getting all mixed up if I was on one band and entered a frequency for another and am wondering if the K3 is the same. - Keith N1AS - - K3 711 - -----Original Message----- From: Dick Green WC1M The K3 manual says the Band switch scrolls through the ham bands. But if I enter a general coverage frequency, say 11.000, it becomes the setting of the nearest ham band. So, when I'm scrolling, I see 7.000, 11.000, 14.000, etc. I have to re-enter 10.100 to get 30m to the right setting. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
