Greg wrote:
Don made a good point. When you assembled the power pole, did you make sure
when inserting the pins that you heard a distinct click? If not, they may
not be completly seated. Try pushing them in more to see if they click.
Greg
-----Original Message-----
From: Dick Roth KA1OZ [mailto:[EMAIL PROTECTED]
Sent: Thursday, May 08, 2008 6:55 PM
To: Greg
Cc: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: Re: ERR VCO Problem Activity Log
Greg wrote:
So Dick...what is it doing now? When the VCO CAL went slowly and the
speeding up some toward the end is correct behavior.
Are you hearing normal signals now? Have you done the REF CAL and TX Gain
CAL?
Greg
{snip}
I successfully ran the REF CAL and TX Gain last night while the radio
was in its glory. Now if I can only turn it on and off when I want
to...(pardon the whine).
What else can I do to provide hints of the radio's health?
--
73,
Dick ka1oz
Middleborough, MA
K3/100(Kit) SN 000859
Titan-DX (to come)
I started with DC. APP connectors are firm in their sockets and no
wiggling causes outages. When I installed the front panel, I was keenly
aware from list traffic that great care had to be taken during this
process. I looked at each connecting point of each connector. I've
also given the baby "therapeutic taps" to see if anything was loose.
If you guys don't mind...its 2317 here and I rise at 0500 to pay the
mortgage, so I'll follow up tomorrow.
ttfn &
--
73,
Dick ka1oz
Middleborough, MA
K3/100(Kit) SN 000859
Titan-DX (to come)
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
